To check whether Bluetooth us more problems or not can be seen in some cases. For example, a Bluetooth connection is lost, and often fails. Or at the time we activate the Bluetooth, mobile phone hangs or total misfire. Bluetooth can not be activated, although we have attempted many times.

We also can check the Bluetooth problem with our attempt to open the gallery on the mobile phone. If not, there is a problem. Or when Bluetooth is activated, MEdia Net can restart itself. In some cases, to a mobile phone can die total. MEdia Net also check whether the fast heat or extravagant Battery, because it can be a misunderstanding on the Bluetooth.

To reduce the risk of damage Bluetooth some ways. First, try not to activate the Bluetooth in the crowded environment, such as in a department or a public place because Bluetooth is a simple insertion of the media mobile phone virus.

If there are incoming messages via Bluetooth is not clear, remove immediately and can be removed if not turn off the mobile phone and then turn back. Perhaps the virus or the application for observer sms or know the content of the data on your mobile phone. We also try not too often have a Bluetooth connection to the Internet.

STEP-STEP

For that is broken, we can perform the following steps. First we must check whether we have the Bluetooth software on the issue. Case used here is the Nokia N70.

1. Check the settings on Bluetooth (Shown to all)
2. Make a Master Reset from the MEdia Net with the pressing * # 7370 #. Be careful because this melakuan risk missing data in the MEdia Net. If you have MEdia Net Code 12345 type. If the code is not acceptable means must be formatted using the computer box or flasher.
3. If you still can not be formatted, try to do the flashing on the Bluetooth.
4. If you still can not flashing on mobile phone program that, most likely the damage is caused by hardware or components.

HARDWARE SOLUTIONS

1. Check the condition of the components in the area if there is a Bluetooth module corrosion (rust water). If dirty clean with liquid IPA (alcohol)
2. Check under this component.

Prepare the following tools:
a. Scissors
b. T6 screwdriver
c. Tweezers
d. Nokia 5110/6110/6150/3210
e. Double tape of 2-4 mm thick.

Step 1
Remove the battery cover back, casual and open an antenna on the back of the screw using a screwdriver T6.

Step 2
Release connector and PCB assemblies.

Step 3
Extract from the LCD cover.

Step 4
Release plate behind the LCD, separate from the front of the frame.

Step 5
Take the double tape, scissors along the top of the frame. But outside the double layer of tape should not be removed. Not to stick with LCD.

Then insert the LCD, how close the press slowly. Mobile phone ready dirangkai again. Enter Battery pray and hope that the LCD is on again. Usually do this successfully. Fair, to save time and costs. Approximately it can make its own service center.

What causes the mobile phone is often restart? This often happens is that because the mobile phone is dropped or a concussion, so the hardware or the connection path that is in the mobile phone becomes loose, broken or dropped out. As a result, so the system does not run normally. The problem also affected the water is a problem that often causes a mobile phone so often to restart. Water or moist air that will make mobile component rust or corrosion so, consequently the ability and function mobile phone hardware components so disturbed.

In addition to the hardware problems software can also trigger the mobile phone like a restart. For example, use a frequency modem to the Internet. This is potentially a mobile phone to restart. With often use a mobile phone processor internetan who are forced to work hard so weak, the system can not process and often lead to a mobile phone restart.

Using too many applications that can also cause the mobile phone so often to restart. Many of the data file cause. This has caused by not read command processor system and mobile phone so disturbed cause mobile phone so often to restart.

How does the solution when the mobile phone is often restart?

If the fall or concussion can be checked IC, CPU, RAM 26 Mhz crystal. What happens to broken or split. If that is the case, can be done by heating or do penyolderan with steam heat.

If they have affected the water means that most likely we have a mobile phone washing machine with liquid IPA.

If you frequently use the Internet or are often used to play games, to the OS to be corrupt must be re memprogram mobile phone is a tool box with the help of a computer with a flasher and special programs.

If, after re-programmed the problem, the possibility of damage caused by the hardware (hardware), if that can not be corrected with penyolderan do so must change components such as IC, CPU, flash and power.

Tips any mobile phone in order to avoid restart

For hardware
a. Avoid from the impact and fell to the hard surface.
b. Avoid mobile phone from where the succulent and moist, because it can result in a mobile phone component corrosion or rust.

For software
a. Avoid the use of mobile phone very often so the modem to the Internet.
b. Avoid the installation program that is too many
c. Avoid playing games too often and too limit.